ĥ) Measure BH -BH is from string to center of Berger hole or threaded hole on shelf that rest bolts to, most stock bow grips will have the same measurement from the deepest point on grip.Ħ) Record CT -Older Mathews have two alignment holes in cam-take two 3/32 pins or finish nails with points grinded, edges bevelled and smoothened with fine sandpaper, and place into alignment holes. I use these steps in my archery shop and have great success with them, every shooter is different and methods may vary, use what is best for you.Ībove all enjoy our great adventure we call archery and Bowhunting.ġ) Loosen limb set bolts on each side of bow on all bows that utilize limb pocket locking bolts-Tighten limb bolts to max-all Mathews spec’s are with bow to max.Ģ) Place bow in bow press bow shelf/rest towards yourself.ģ) Recording all measurements in the next steps will assist in understanding movements in different stage’s of tuning to bow spec’s.Ĥ) Measure ATA, using tape measure or metal yard stick/straight edge, measure ATA from OC. This tuning guide is just that –a “guide” these are methods that have been developed by myself, and combined with methods by other knowledgeable people I have a few of these on the Mathews forum this first one has amazing 83677 hits on it so it shows it is being used. Sorry if this has been done before.but lets start up a Bow tuning and set-up Tip thread.that we all can contribute to and maybe learn something.I learn something new every day in this archery/bowhunting sport.

Mathews switchback xt cam numbers